Resetting to Factory Default Settings

If the camera no longer functions as expected or if you are unable to focus the camera heads, you can choose to reset the camera to its factory default settings.

Use the firmware revert button to reset the camera. The firmware revert button is shown in the following diagram:

Note: Be careful not to scratch the dome bubble.

Figure 3: The firmware revert button.

1. Ensure the camera is powered on.
2. Remove the dome cover.
3. Using a straightened paperclip or similar tool, gently press and hold the firmware revert button for two seconds.
4. Re-install the dome cover.

CAUTION — Do not apply excessive force. Inserting the tool too far may damage the camera.