Mounting the Optional ES-HD-MNT-PAR Parapet Mounting Adapter

Complete the following steps to mount the enclosure using the optional ES-HD-MNT-PAR mounting adapter.

Installing the IR Illuminator

  1. Refer to the H4 LPC Site Design Guide to determine if the IR illuminator's lens needs to be changed or removed. Please consult the printed installation guide shipped with the IR illuminator for instructions on replacing the lens, if required.
  2. Align the IR illuminator's bracket holes and mounting adapter holes with the mounting holes in the housing, as shown in the diagram below.

  3. Use the included screws to secure the IR illuminator and mounting adapter to the housing. Tighten the screws using the provided allen wrench.

  4. Connect the IR illuminator directly to a Power Injector and not via the camera enclosure.

Connecting the Housing Cable

Once the housing and mounting adapter have been mounted to the desired location, follow the steps below to connect the PoE cable:

  1. Pull the required PoE cable from the Power Injector. The PoE cable will be routed through the largest cable opening on the bottom of the enclosure.

  2. Use the sealing ring to seal the cable connection through the enclosure. Ensure that the unused holes on the bottom of the housing are sealed with the remaining sealing rings to prevent water from entering the housing.

    Note: You will need to crimp the PoE cable to pull the wire through the sealing ring.